![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/orig.jpg)
Remove the turret by unscrewing the 5 screws.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/beff.jpg)
Now its time to remove the Ars. I used a hammer and a sccrew driver.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/drill.jpg)
Now you are going to want to remove the bottom of the turret. With a cutting tool cut away less than 1/2 an inch from the bottom.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091033.jpg)
Now you are going to cut along the bottom of the lip at the top of the turret.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091035.jpg)
When cut, it should look like this:
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091049.jpg)
Now using a cutting tool cut the top of the turret at each "v"
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091050.jpg)
And when finished it will look like this:
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091059.jpg)
Now make 20, 2.5 inch cpvc barrels.
Place the bottom of the turet back in the gun and screw the top back in.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091107.jpg)
Now begin to install the barrles. The cpvc should fit perfectly inside the bottom of the turret. I used hotglue and only in the top bart of the turret.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091112.jpg)
When intalled it will look like this:
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091116.jpg)
Now on to the BBBB part of the gun.
Begin by opening up te gun and cutting the black tube about .25 of an inch after it is in the turret.
Next take a length if 3/8 brass that is 2 inches longer than the current black tube. Put e-tape on one of the ends and 2 inches fron the other end.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091125.jpg)
Now cut a 2in lentgh of cpvc and put it on the brass up to te e-tape.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091134.jpg)
Now put it in te black barrel and test it. You may need to add a spacer between the black barrel and the cpvc.
Once you are happy superglue the brass into the black barrel.
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0819091154.jpg)
Now put the gun back together.
It should look like this:
![Posted Image](http://i731.photobucket.com/albums/ww318/numa-t49/0820090809.jpg)
Now add a coupler and a speed loader and you are done.