Remove the turret by unscrewing the 5 screws.
Now its time to remove the Ars. I used a hammer and a sccrew driver.
Now you are going to want to remove the bottom of the turret. With a cutting tool cut away less than 1/2 an inch from the bottom.
Now you are going to cut along the bottom of the lip at the top of the turret.
When cut, it should look like this:
Now using a cutting tool cut the top of the turret at each "v"
And when finished it will look like this:
Now make 20, 2.5 inch cpvc barrels.
Place the bottom of the turet back in the gun and screw the top back in.
Now begin to install the barrles. The cpvc should fit perfectly inside the bottom of the turret. I used hotglue and only in the top bart of the turret.
When intalled it will look like this:
Now on to the BBBB part of the gun.
Begin by opening up te gun and cutting the black tube about .25 of an inch after it is in the turret.
Next take a length if 3/8 brass that is 2 inches longer than the current black tube. Put e-tape on one of the ends and 2 inches fron the other end.
Now cut a 2in lentgh of cpvc and put it on the brass up to te e-tape.
Now put it in te black barrel and test it. You may need to add a spacer between the black barrel and the cpvc.
Once you are happy superglue the brass into the black barrel.
Now put the gun back together.
It should look like this:
Now add a coupler and a speed loader and you are done.
