Fitting Swiftnerf Foam Into Omc Petg
#1
Posted 29 July 2009 - 01:56 PM
I beat my wife."
#2
Posted 29 July 2009 - 02:03 PM
#3
Posted 29 July 2009 - 02:04 PM
Edited by stuck by stefan, 29 July 2009 - 02:04 PM.
This is the NerfHaven profile of Northeast Designs. For more info visit https://www.facebook...p8OwIso&fref=nf
Old school Nerf engineer since 2008
#4
Posted 29 July 2009 - 02:05 PM
I've been heating it too much then. like 20 seconds and then putting them in the freezer for a few mins. How would you stretch them?What is your heating method? Either you are not stretching it enough or you are heating it too much. My method of heating is 10-15 second of indirect heat via blow dryer.
A little too late for that.Use med. walled petg.
I beat my wife."
#5
Posted 29 July 2009 - 02:07 PM
Rainbow Clan
#6
Posted 29 July 2009 - 02:13 PM
You can stretch the foam by putting it in varying ID tubes (CPVC, Sch. 80 PVC, brass, PETG, etc.) for a day or so each.I've been heating it too much then. like 20 seconds and then putting them in the freezer for a few mins. How would you stretch them?
#7
Posted 29 July 2009 - 02:15 PM
Use med. walled petg.
[/quote]
Medium Walled is not necessary. My foam will fit thick walled. I have made darts with ever 100 feet or so and have been getting same results.
[quote name='Norther_of_Heaven' date='Jul 29 2009, 11:05 AM' post='244557']
[quote name='SwiFTNerF' post='244555' date='Jul 29 2009, 03:03 PM']
What is your heating method? Either you are not stretching it enough or you are heating it too much. My method of heating is 10-15 second of indirect heat via blow dryer.
[/quote]
I've been heating it too much then. like 20 seconds and then putting them in the freezer for a few mins. How would you stretch them?
To stretch the foam, just pull it in little sections (4-5 feet or so) before cutting. Stretch foam to just before breaking point. The blanks that you made after heating for 20 seconds should fit medium walled.
[quote name='atomatron' date='Jul 29 2009, 11:07 AM' post='244558']
It sounds like you got some of that larger stuff he had, it apparently fits well in sch80 PVC.
[/quote]
No, he did not received stuff from my bad roll. I would not sell bad foam to anyone if I knew it was bad. All the foam I am selling now is from a new spool. This new spool is slightly larger than my original stuff but no where as bad as the other spool I had previously.
Edited by SwiFTNerF, 29 July 2009 - 02:24 PM.
#8
Posted 29 July 2009 - 02:25 PM
I beat my wife."
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users