My pictures are big so you can see shit later, so don't bitch at me about it please.
The day after I got home, whilst floating in a sea of boring...ness, I decided to rip that sum' bitch apart.
I started by, obviously, taking all the screws out but that blue piece gave me some problems.
Do this to get the internals out of the shell if you're lazy like me.
I noticed that the internals fit almost perfectly into a hollowed out maverick shell. (I had one from a failed nitemav)
After a considerable amount of sanding and cutting, you get this. KEEP THE TRIGGER SPRING!
The pump tube is a little larger than the inside of the mav shell, so the slot serves a dual purpose. ( To alleviate some pressure and to make it possible to pump with the slide handle.)
Next is the task of getting the airtank and whatnot to fit in. You'll can pretty much eyeball it because later on that part wont really be essential.
You get something like this.
Third(?) is to cut out the part of the area around the trigger, but not so much that would let the trigger move around too much.
The picture is blurry, but you get the picture. (no pun intended)
Do this!
Also this!
I used part of a spring from a broken airsoft gun to tie the ring to the fireing pin.
Drill a hole through half the slide, through the hole in the pump, and then put your other half on and finish drilling. Put the rod from the mav turret through the hole and cut it to length, and glue to your little heart's content.
Now you can fit everything in there and it will fit if you did it right and i didn't leave out a step that you can't figure out.
You can just stop here and throw a coupler or something on the existing barrel, make a hole for the barrel and leave it at that.
I, on the other hand, decided to make it look pretty... kinda... not really, but it looks better after this.
So, you cut the front of the mav shell and nest some 1/2'' cpvc in your recon barrel. Make sure to leave room for the existing barrel to fit inside the recon faux barrel. I like to put a piece of a big blast barrel inside to make it easier to get the dart to fit into the cpvc.
You get something that should look like this.
The recon sight is just to look pretty.
To finish this up you take the top of the mega missile shell and cut it down to look like this
YOU'RE DONE WOOOOOOO!!!!
Ranges are around 100-110 feet.
Edited by princexbuster, 11 June 2009 - 07:48 PM.
