10 replies to this topic

[idk59]

New Snap pistol. It is really really small. The shell excluding the plunger is smaller than the barrel which is 6 in.

A side view of the gun.
Ranges of this pistol is about 55-70 ft flat. These ranges are very nice compared to how small the gun is.
I have some questions about the plunger.

View of the plunger.

View of the plunger head.

I thought this might get a little better result in the ranges so I put an o- ring there.
Does anybody have any advises on a better plunger? Thanks

[aishihigeo]

Can you post a picture of it compared to a maverick to determine its size.

[cheesypiza001]

Use rubber washers. They create the best seals.

[Chris is cool]

Never mind.

Edited by Chris is cool, 24 May 2009 - 11:44 PM.

[cheesypiza001]

I'm really confused on how that plunger catches. Can you give me a run-down on how that thing works?

It's called a Clothespin Trigger.

Edited by cheesypiza001, 24 May 2009 - 11:43 PM.

[Carbon]

I'm really confused on how that plunger catches. Can you give me a run-down on how that thing works?

It's called a Clothespin Trigger.

I think the question is more about where the catch is located, since the plunger is missing the usual rear catchface. Does the nail hold on the front of the plunger head?

[idk59]

I have cut off the pinty part of the nail so itwon't cut anything but the nail does go in front of the plunger head.

[rork]

You still need a catch. Anything seal-related will not take kindly to being forced over a steel rod, no matter how dull.

[hopper055]

You can tell buy what I have circled. That the dull nail is damaging your plunger head. here take a look.

[alextwin007]

I posted something similar to this on Lt. Stefan, but yours is way nicer.

[MercenaryXero]

How do people tolerate right-angle grips? In my experience, they just hurt your hand.