1in. spring 4 to 6in. long
1in. screws
scrap 2X4 (optional)
fishing line (any string will work too)
screw driver
metal rod (or small screw driver)
card board
Tools needed: hand saw or rotary tool
drill
drill bit slightly bigger than metal rod or screw driver
hot glue
hot glue gun
1in. drill bit (preferably a drill press)
Cut bottom of 1in. by 1ft. pvc at an angle
drill hole in the side of the pvc pipe 4in. away from bottom for the metal rod.
drill 1in hole in the middle of the 2X4
insert pvc in the middle hole so the bottom side that has been cut is 1in. bellow the wood and drill into the side of the wood to hold the pvc in.
hot glue a 1in. piece of cardboard on to one side of the spring. Then drop the spring down the pvc (side with cardboard facing upward).
Tie your fishing line (or string) to your metal rod (or small screw driver) and the other end to your screw driver.
then screw screws downward in the wood for stabilization.
\
push down on the spring with a pole or long screw driver
insert rod into hole to hold down the spring once held down
pull rod out of pvc and insert your ammo (ill be adding later on how to make good ammo for it)
jab claymore into ground then jab screw driver attached to fishing line far enough away so the line is tight.
when someone tripps the line it pulls out of the pvc which lets the spring go and push the darts out in a shot gun effect
I initially tried to upload pictures but my S.D. card is not connecting to my computer so i will up load pictures of the build A.S.A.P. and cont comment if u don't have anything nice to say.
Edited by daboogymann, 06 May 2009 - 09:06 PM.