Sorry if the pictures get messed up this is my first time posting pictures.
You will need
A Nitefinder
A hacksaw (or what ever you use to cut)
A drill
A file/sandpaper
And a key ring
Here is the MiniFinder.
It has a cpvc barrel on. You need a barrel in order to remove the piece around the stock barrel. If you can't get cpvc, or any other piping, open up a crayola marker, or roseart, and get just the shaft and drill/dremle out the insides and glue it on the AR.
This is similar to what your NiteFinder should look like. (Sorry its different then the one I modded I cut berfore I took pics.)
You can cut here. I did because it gives my had just enough room to fit my index to ring finger on. Yes my hand is small I am only 13. YOu can cut somewhere different to fit your hand.
Cut along this line. Sorry if its a bit hard to see.
Finally cut here. I would take the cocking handle piece out for this. I did but you might not need to.
Now drill a hole at the end. The size can differ depending on how big of a key ring you have.
Now put a key ring in the hole. Make sure its a strong enough ring especially if you have a strong spring. You might be able to use wire but it must be strong.
Now sand down near the sides so the key ring can get as far in the gun as possible, to reduce size.
Here is the gun cocked.
Here is a size comparison to a full sized Nitefinder.
And lastly a comparison to a modified Crossfire.
The ranges are the same as any other NiteFinder. But in a smaller package.
Comments? Tips? Flames?
