9 replies to this topic

[lambchop]

Can someone give me a link to a roto rocket mod. I have searched but can seem to find any. I want to single it so if anyone could help it would help. I also want to make it so i can shoot it flat.

[Draconis]

Can someone give me a link to a roto rocket mod. I have searched but can seem to find any. I want to single it so if anyone could help it would help. I also want to make it so i can shoot it flat.

Don't micro dart single it. You'll injure someone. As for horizontal use, remove the covers and take out the little oval piece under the trigger. You are going to need a triangle screw driver to remove the covers. I made my own. As for barrel mods, I am using a 3/4" PVC compression coupling. It has a rubber ring that compresses down around the barrel when the flange is tightened. On the other end is a 3/4" MIP fitting. I wish I could find one that was a female end, but it works out fine for the ball adapter.

[lambchop]

Pics could help some. Not trying to be a jerk.

[Draconis]

Pics could help some. Not trying to be a jerk.

Oh jeeze... Put in a little effort here, kid. This is probably THE easiest blaster to modify, precisely because there is very little to do. Put a barrel on the end, and take the stupid limiter out. Done. There are no complex inner workings you need pictures for.

[lambchop]

Could a 1/2 inch cpvc coupler fit and be glued inside the barrel?

[Quilan Fett]

Nope. See, the barrel is part of the tank. So don't cut it.

[lambchop]

What coupler will work so i can use 1/2 cpvc?

Edited by lambchop, 20 February 2009 - 10:34 PM.

[Darth Tom]

Maybe one of those 1/2" CPVC couplers would work. You know, the couplers made specifically for 1/2" CPVC, and are usually sold right next to the CPVC itself?

[lambchop]

Maybe one of those 1/2" CPVC couplers would work. You know, the couplers made specifically for 1/2" CPVC, and are usually sold right next to the CPVC itself?

Yes but would the cpvc coupler fit around the barrel?

[Darth Tom]

Just wait until you get the Roto Rocket. It makes much more sense that way. You can take a barrel diameter measurement of the RR, and go to the hardware store. Bring it if you want. Then, you can see what size couplers/PVC fit over the stock barrel. I would e-tape the stock barrel until a size of PVC fit over it snugly, and then put a PVC coupler on the end. This would be a pretty sturdy setup. Then, you can e-tape whatever barrel material you use, put it in some PVC, and put your barrel in the coupler.

A shotgun attachment would be wise, if you ever intend to shoot this at someone. You'll probably never be able to use it at a war, but among friends it would probably slide. You should only ever use the singled barrel for seeing how many cans you can shoot through, if the dart even survives.