#1
Posted 17 February 2009 - 03:28 PM
#2
Posted 17 February 2009 - 03:31 PM
The trigger is being held open by something in the shell.I finished my modification to my bbbb but when i put the gun back in the shell it will pump but the air wont stay in. But when the gun is out of the shell it works fine. Could some help.
Check for any obstructions, then try it.
<3
#3
Posted 17 February 2009 - 03:33 PM
Edited by lambchop, 17 February 2009 - 03:35 PM.
#4
Posted 17 February 2009 - 03:36 PM
The trigger is crooked on the pin then..I hot glued the trigger onto the metal pin cause i gave up on it and decided to use it without the shell. But it worked with the hot glue on it outside of the shell.
When the shell is closed, it causes the pin to tilt to one side, making it leak.
Try removing the hot glue.
<3
#5
Posted 17 February 2009 - 03:40 PM
The trigger is crooked on the pin then..I hot glued the trigger onto the metal pin cause i gave up on it and decided to use it without the shell. But it worked with the hot glue on it outside of the shell.
When the shell is closed, it causes the pin to tilt to one side, making it leak.
Try removing the hot glue.
Ok i am trying it right now
#6
Posted 17 February 2009 - 04:02 PM
What you have to do is glue the tank as far back in the shell as you can.
#7
Posted 17 February 2009 - 04:11 PM
This has spiraled beyond uselessness into utterly stupidy.
Read it again until you figure it out.
#8
Posted 17 February 2009 - 04:28 PM
#9
Posted 17 February 2009 - 04:35 PM
#10
Posted 17 February 2009 - 04:37 PM
This has spiraled beyond uselessness into utterly stupidy.
Read it again until you figure it out.
#11
Posted 17 February 2009 - 04:38 PM
#12
Posted 17 February 2009 - 04:46 PM
Edited by twenty4, 17 February 2009 - 04:49 PM.
#13
Posted 17 February 2009 - 05:06 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users