Frame is made out of card board, and its all duct taped together, on the inside and out. It is held onto my belt via a strap with a clip, so it is easily detachable. The loops that goes onto my leg is one of the shoulder straps from the backpack that I cut up to make this. This whole thing was real easy to make, and consists entirely of cardboard, duct tape, stuff from a back pack, and a bit of zap a gap to glue some of the straps together. I don't think a full write up is necessary, it should be easy enough to replicate. Just first cut out 2 pieces of cardboard that are the general shape of the gun. Then put the gun between them and use smaller pieces of cardboard and duct tape to space the two cut-outs. Just make sure its a snug fit on the gun. You don't want your side-arm falling out when your running.
Here it is on me. Pictured from the front.
Here's more of a side shot.
Here's what I see when I look down.
And finally, here's a pic of what it clips into attached to a belt.
I hope you all like it. I'm very pleased with it, its very functional. If you have any questions about it, feel free to ask. I'd also love feedback.
Edited by TantumBull, 08 February 2009 - 12:12 AM.