Step 1: With your recycled piece of card board make many bends and curves in it so it will bend and become circular more freely.
Step2: Make a cylindrical shape with your cardboard with a nice hole down the middlethat would fit a dart nicely and tape it up around the outside so only a small flap on the inside of the cardboard can move(the little flap is where the cardboard ends)
Step3: Sturdy the inner flap of your cardboard by slipping a small piece of tape down it and taping the flap or end of the cardboard to another layer of its inerts and wrap the rest around the outside of the dart carrier.
Step4: Apply your good glue to the spot where you would like to put the dart carrier and merely put it there. After it dries plop some tape over that bad boy so it will be close and sturdy to the gun.
Step5: Make sure your bullets with large tips fit in.....hopefully you will enjoy your almost no cost dart carriers!!!!!!!! Hopefully your ROF will be increased a little
Edited by Chris is cool, 08 February 2009 - 09:24 AM.