mats:
1/2 pvc
17/32 brass
9/16 brass
hot glue gun
drill bit
screw of your choice
dremmel
Step 1
Grab your 11-12 inches of pvc and 17/32 brass and mark where you want to dremmel your loading area. Do the same with your brass. I made a 1 1/2 hole.
step 2:
do some cutting of where you marked.
step 3:
after you cut your brass and pvc make a hole in your 17/32 brass behind your loading area.
step 4:
cut a path for your bolt, like so, on your pvc.
step 5
put e-tape on each side of a piece of 9/16 brass til it fits perfect and glue it in. Make sure it is flush with the insde of loading area and the bottom of the pvc.
step 6
Then cut the brass while its in the pvc where your original bolt path was.
step 7:
Ok, now push your 17/32 into your 9/16
step 8:
now put your bolt in the hole you drilled into the 17/32 brass.
final product? you decide.
Thanks
~Thaygor
Edited by thaygor, 18 January 2009 - 03:43 PM.