Jump to content


Photo

Single Pump At3k

something new, I hope.

4 replies to this topic

#1 Mr BadWrench

Mr BadWrench

    Member

  • Members
  • 781 posts
  • Location:Bum Funk Ohio

Posted 13 January 2009 - 03:02 PM

Posted Image

have not rebarreled yet...

Posted Image

I cut the plunger, ran a piece of 1/2in dowel rod down the middle of the hollow plunger rod and positioned a small piece to allow the rotation mech to slide...

Posted Image
Posted Image

the rod down the middle of the plunger plugs the pump, allows about 2in more plunger travel and puts the pump in a nicer place to use...

I suggest a fiberglass rod or anything but wood but it does work...

Don..
  • 0
NerfChat IRC Chatroom Click to chat!

#2 Garrett76z

Garrett76z

    Member

  • Members
  • 89 posts

Posted 13 January 2009 - 03:18 PM

Looks good man. This is mine from a couple years back...

http://nerfhaven.com...wtopic=8049&hl=
  • 0

#3 Drew is nerfing

Drew is nerfing

    Member

  • Members
  • 77 posts

Posted 13 January 2009 - 03:20 PM

cool. I would suggest a barrel replacement. Then you should post ranges and such. Is the pump plugged? because if it is, you could make it a 2 pump and get better ranges out of it.
  • 0

#4 VACC

VACC

    Vacc is Legend

  • Founders
  • 3,265 posts
  • Location:New York
  • State:New York
  • Country:United States

Posted 13 January 2009 - 03:51 PM

He specifically said that he has not replaced the barrels "yet", which implies that he intends to. He also explained that the wodden rod plugs the pump. Read a little before posting.
  • 0

#5 veginator

veginator

    Member

  • Members
  • 301 posts
  • Location:Savannah, GA

Posted 13 January 2009 - 09:06 PM

Looks good man. This is mine from a couple years back...

http://nerfhaven.com...wtopic=8049&hl=


In fact this has been done at least three separate times before. I did one a couple months back and some one posted yet another example of it being done.
Search: at3k pump extension
Sorry no link, new internet provider

Edited by veginator, 13 January 2009 - 09:09 PM.

  • 0


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users