Jump to content


Tech Shot Integration

an integration

4 replies to this topic

#1 wawa



  • Members
  • 12 posts
  • Location:laurel, MD

Posted 01 January 2009 - 10:00 PM

Posted Image
this is a writeup explaining how to integrate a pocket blaster with a tech shot

3" cpvc
tech shot
pocket blaster

tools: (required)
Philips head screw driver

tools:(not required but helpful)
hot glue gun

1. remove all the screws holding the pocket blaster closed

2. cut the end off the barrel off the pocket blaster and drill out the peg the dart sits on.
Posted Image

3.make the following cuts on the tech shots shell, this is where the barrel of the pocket blaster will be
Posted Image

4.open the tech shot and pull out the barrel and plunger assembly
Posted Image

5. the barrel should pull right off from the plunger tube,then slide the cpvc over where the barrel used to be, it should fit perfectly glue it on if you want.
Posted Image
Posted Image

6. replace the plunger and barrel assembly and make these cuts to the inside of both sides of the shells,
when cutting the hole for the pocket blasters trigger only cut out the bottom of the shell
the pic wouldn't work so here is a link

7 place the pocket blaster in the area that used to hold extra darts, glue it in if it moves around too much.
Posted Image

8. close the case and put the screws back in.
tada! a fully modified and integrated tech shot

tech TARGET 50FT
pocket blaster ?

(it is possible to mod and integrate these guns using only a saw and a screwdriver)

Edited by wawa, 02 January 2009 - 07:16 AM.

  • 0

#2 Rogue Warrior

Rogue Warrior


  • Members
  • 320 posts
  • Location:Overland Park, Kansas

Posted 01 January 2009 - 10:02 PM

Creative, but you could have taken it a step further by rebarreling the pocket blaster.
  • 0
My GT is Spacecowboy9951

#3 loni



  • Members
  • 78 posts

Posted 01 January 2009 - 10:13 PM

Im sure someone has done this already, but that could also be easily done to a NF to use some of the dead space where the laser is (1st gen) or the ammo holders.

On Topic: Good mod! could use better cosmetics but it is a good idea. By doing this you basically made a tertiary "gun" built into your secondary gun.


Edited by loni, 01 January 2009 - 10:14 PM.

  • 0
"I don't nerf to see who is the best, I nerf to see who is the biggest bitch"

#4 Betrayal



  • Members
  • 115 posts
  • Location:BC, Canada

Posted 01 January 2009 - 11:28 PM

Isn't that called the Tech TARGET? On topic: Nice mod.
  • 0
QUOTE(VACC @ Apr 15 2009, 11:23 AM) View Post

Doing shit is hard work.


#5 wawa



  • Members
  • 12 posts
  • Location:laurel, MD

Posted 02 January 2009 - 07:14 AM

when i did this i only had a saw and a screw driver, if i had had epoxy with me i would have made a cpvc barrel for the pocketblaster
loni - someone has done this to a night finder before, i saw it at the last dcno and thought the space in the tech target was perfect

Edited by wawa, 02 January 2009 - 07:18 AM.

  • 0

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users