A red light accessory from a recon
First, cut of the goo gauge, the tubing connecting the gauge to the tank, the plastic counected to the bottem of the tank, and all of the firing pin behind the black nub. You should end up with this.
Next, connect the tubing from the pump to the tank. Seal it up with hot glue.
Third, take the useless red light included with the recon and remove the guts. Then cut out all that I did
There is some plastic cut out to make room for the hose
you might have to cut and/or sand some other parts to get it all in.
Fourth, fit the internal in like this
Fifth close it all up. It wont quite fit, so use every screw to hold it in.
Sixth glue the top of the pump to the bottom of the shell. USE A LOT OF GLUE.
Lastly i cut a piece of plastic and bent it until it would stop the pump from coming out if glued to the bottom.
Edited by TheBolt, 20 December 2008 - 10:02 PM.