When you look at it look at the little hole where the air comes out. Also look how the air comes out by pushing the stick into the thing.
For this mod you need...
--------------------------
- Hot glue
- 1/2 in. Cpvc cupler
- Scissors
- Rubber bands
First off take the 1/2 in. CPVC cupler and glue it over the little hole.
If you want, take a drill and drill the hole bigger for better air flow.
After that take the scissors and cut a little notch in the foam like so.....
Continue doing it, and make 4 little notches around th cupler.
Then go to the back of the gun and cut two notches there as well, like so...
Once done with the notches, take two rubber bands and connect them together.
Then, put it into two of the notches and bring it down to the other two notches in the back.
Put two on each side. Anymore and the dart will fly out of the barrel and go about 3 FT.
Once done with it, should look like this.
To load the gun
------------------
step 1 - Pull back the stick without a dart in it.
step 2 - Load the dart in the barrel without letting the stick go.
step 3 - The stick will stay back after the dart is in because the air can't get out.
step 4 - When ready to shoot push it forward as hard as you can.
Ranges - The harder you push in the farther it will go. 45-50 ft.
Thanks this was my first write up.
If you have any suggestions please tell me.
Questions, Comments, Flames????
Edited by Connor, 20 December 2008 - 03:20 PM.
