Items
Disc shot(duh)
Glue(super and hot glue)
2+ crayola markers(One is needed more are optional.)
Tools-
Pliers
Screw driver
Cutting device
Ok first the a.r.'s.
Sorry about the bad/no pictures plus i only have pictures of the completed gun.
Unscrew all the screws and disassemble all the barrel pieces and this is just a basic a.r. mod not that hard just snap of the stem and remove the little tri- winged thing.
Next take your marker number one and gut the marker out just salvage the cap the cone piece and the marker tube
the black thing on the end is the conethis part is a little confusing so bare with me. So you are going to take the two plates that the a.r.'s where attached to and stick them back together now take the cap of the maker and cut the marker cap off about 2cm past where the marker piece connects into it now take a drill and clean it out so there is nothing but just the sides of the cap then hot glue and/or super glue onto the a.r. holder that had the stem part on it
barrel holders-(optional)- now to make use of those ammo holders now take some more marker barrels(still with the cone piece on) and just hot glues the caps into the hole where the ammo holds used to be
now resemble the gun and you have your removable barrel system
(no barrel)
(with barrel)modified iron sights-(optional)
to make the modified iron sights what you need is
a small plastic rod(i used a Que tip)
about 1.5 inch section of a crayola marker
and hot glue
ok so what you did is take the hot glue gun right on the flat spot (on top of the barrel)(in front of the rail attachment system[R.A.S.])
(placement) and stick the tube right on the center then take a plastic rod and glue it in front of the tube 
(Looking down the iron sights.)
ranges (feet)
flat
shot 1-28.58
shot 2- 24.16
shot 3-21.25
avg- 22
angled
shot 1-24
shot 2-18.91
shot 3-25
avg-22.64
Edit= ranges + redone the whole thing will be better tomorrow.
Edited by nerfer9987, 14 December 2008 - 09:51 PM.
