1. The AT2k pump was far too big for the Speedloader shell.
2. The AT2k plunger would come out of it's tube if pulled too far or too vigorously pumped.
A quick, cheap, and clean solution to this problem;
Materials
Disposable Waterbottle Cap
Utility/Exacto-Knife
Sandpaper
Dremel
Electrical Tape
Instructions
Examine the bottle cap, there should be a threaded outer rim and a smaller inner rim used to seal the bottle. Use your hobby knife to cut the outer rim away, while leaving the inner rim intact.
Sand the rough edges down.
Next take your dremel and put a thick, clean "+" symbol square in the middle of the bottlecap. Cut one side of the plus all the way through the edge of the cap so it will fit on your plunger.
Slap it onto the end of the plunger pump tube and generously apply Electrical Tape
It should end up looking something like this.
Questions, comments, or flames to contribute?
