So my at2k isn't holding air... I've tried silicone spray, silicone grease, etc. I'm wondering if its just because the pump isn't pushing enough air at a time. Would a new oring fix this?
At2k Question
Started by Kid Flash, Nov 01 2008 02:03 PM
2 replies to this topic
#2
bpso86
-
- Members
- 618 posts
Member
Posted 01 November 2008 - 02:14 PM
Can you hear air whistling out of the front of the barrel? Can you feel any pressure at all going in? My bet would be on the rubber piece which seals the air tank got misaligned so that it can't make a seal anymore (this is usually what happens on my at2k's which fail). If this is the case, then I haven't seen a good way to fix it aside from getting a whole new blast chamber.
A new o-ring on the pump won't do you any good.
A new o-ring on the pump won't do you any good.
#3
Kid Flash
-
- Members
- 1,985 posts
Member
Posted 01 November 2008 - 05:22 PM
No... it will hold the air if I just press against the barrel to make a seal long enough to get pressure to hold the piece on the airtank so it will hold the air.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
