Essentially all you are doing is taking the plunger tube out of a Longshot and squeezing it into a NF.
These are the only parts that you will need.
You will have to use a slightly bigger screw and with a lot of hammer pounding put the (I dont know the official name for it, but its the round end piece that has the O ring around it.) Put a BBB spring in it and screw it all together.
Next you must cut the back 3/4 of an inch off the back of the LS's plunger tube. You will have to cut and bend the plastic inside and out of the NF to make it fit. There's no exact way to do it. Screw it together, and super glue the plunger tube to the NF, this prevents it from sliding out when being fired.
I'm trying to add some stability to almost the entire gun. Its so fragile if you drop it on grass it might come apart.
No official ranges yet, but it shoots much farther than any-other NF I've seen.
And yes the basic AR removal was done to the LS barrel.
Edited by nerfnerd88, 29 October 2008 - 05:42 PM.