13 replies to this topic

[Exal]

I want to mod my new Titan! Unfortunately, I can't get the orange plastic peice off.
I have tried a flat head screw driver, but it goes out about 1/25 of an inch.
Any advice on removing it?

[Banshee]

Hacksaw? Pipe cutters? Your brain?

[Exal]

My pipe cutter is to small, My hack saw has a nub at the end that won't let me cut, because there isn't enough
room. My brain can't come out of my head, cut the orange plastic peice for me, and return
back into my head. =D Just a little information for you.

[BendyStraw]

I just dremeled mine off. If you don't have the right materials to do the job, we can't really help you. You could try prying it off with a flathead screwdriver because, if I remember right, it is merely glued on.

[TheNerfLoki]

Try the screwdriver on all sides.
Edit: If It still won't come off: put it on the ground, step on a half of the shell, yank the other half. Or just use some FALCON PUNCH.

Edited by TheNerfLoki, 11 October 2008 - 03:10 PM.

[nerfboi]

Cut it off with your dremel cut off wheel.

[Rogue Warrior]

Or just you know, Falcon Punch it. What you can do is to unscrew all the screws and just pull the case apart.

[Echnalaid]

Or just you know, Falcon Punch it.

Edit: If It still won't come off: put it on the ground, step on a half of the shell, yank the other half. Or just use some FALCON PUNCH.

That. Is. My. Line. I am offended.
On topic- a hacksaw works fine, or snap it off.

Edited by Echnalaid, 11 October 2008 - 04:57 PM.

[tatertotguy]

I personaly, think you should use your dremel cut off wheel.

[Foam Shooter]

On mine I took a very small flat head screwdriver and hammered it in. I continued doing this until I got halfway around and then I just pried it in half. Pouring a beverage on it only work 50% of the time.

[Watari]

So your pipe cutter is too small, and your hacksaw won't work 'cause it has a nub, well modding a Titan was one of my first things, I didn't know my Dad had a pipe-cutter and I didn't have a hacksaw...
Guess what I used...
A SERRATED KITCHEN KNIFE
No seriously, I did, cut at the top of the gun, along the groove, and at the bottom of the gun too.
EDIT: Did you even search?

Edited by Watari, 12 October 2008 - 12:22 AM.

[Aj]

To open up my Titans I heated up a knife (box cutter etc) and cut the plastic in line with the seam on the Titan. I heated mine with a gas stove burner but a lighter can work if that's all that's available.

Aj

[Bomberman]

My Titan got a Visit from Mr. Screwdriver and Mrs. Hammer.

[CaptainSlug]

Any advice on removing it?

My advice is that you actually use the search feature and the modification directory before you get suspended.