4 replies to this topic

[tatertotguy]

I picked up this nice marshmallow shooter at the thrift store for 80 cents. It came with some foam pellets that didn't go very far. The plunger pull is massive it puts out a lot of air pressure. Here's the mod.

Tools:
Dremel
hot glue or some epoxy

Materials:
cpvc coupler
a piece of fbr or some foam

First cut off the front end where it narrows Dont cut it flush with the blue plastic piece that holds the front on. Then take the ammo tube off the back and shove your piece of fbr or your foam in the back of the place where the air comes out don't shove it in too far because it will cut off air flow. Next fill the back with hot glue. Then put your coupler on the front add a bungee and your done.
Here's pictures.
This shows the coupler on the front and the bungee placement.

THis picture shows the massive plunger pull.
http://i333.photobuc...allowgun003.jpg
The ranges it gets are 80' flat and about 100' angled.
Sorry about the picture size.

Edited by tatertotguy, 05 October 2008 - 05:17 PM.

[Split]

Holy crap! That's awesome! I had dismissed the one that badger had as low potential, but this thing is a beast! Much props. I have a marshmallow shooter of my own to work on, of a different type though. By the way, someone please buy that shooter off of badger, and then some more stuff.

[Aimless]

Nice, I bet the recoil feels awesome too.

[TantumBull]

That's insane! It's hard to believe that a marshmallow shooter has such a huge plunger pull.

Edited by TantumBull, 05 October 2008 - 09:01 PM.

[Daecu]

Something to go on my list of cheap stuff to buy O_o Nice find, thanks for sharing