Tools:
Dremel
hot glue or some epoxy
Materials:
cpvc coupler
a piece of fbr or some foam
First cut off the front end where it narrows Dont cut it flush with the blue plastic piece that holds the front on. Then take the ammo tube off the back and shove your piece of fbr or your foam in the back of the place where the air comes out don't shove it in too far because it will cut off air flow. Next fill the back with hot glue. Then put your coupler on the front add a bungee and your done.
Here's pictures.
This shows the coupler on the front and the bungee placement.
THis picture shows the massive plunger pull.
http://i333.photobuc...allowgun003.jpg
The ranges it gets are 80' flat and about 100' angled.
Sorry about the picture size.
Edited by tatertotguy, 05 October 2008 - 05:17 PM.