ratcheting pipe cutter
cpvc and coupler
Firs off cut off most of the barrel. Easy measurement cut to the F in the nerf logo. Also, make this cut as straight as you can following the normal direction of the barrel.
Now you have this.
First add hot glue and when that dries ad the goop so it will hold. Also, rough up the area you are gluing.
Now cut a barrel anywhere from 4-6 inches. I used about 4.5 more for when I band it.
I would have replaced the spring but there are no screws just glue holding it together.
Bam, at least 35' flat.
Questions, comments, flames?
Edited by NerfCrazy, 01 September 2008 - 11:47 AM.