I can't quite do a full write-up at the moment, I will if there is a lot of demand for it though. It's basic anyway. The tubing for the air tank is cut off at the goo gauge. Then, I used a compression connector, 1/4" OD connector x 1/8" Male thread, to connect this to a secondary tank:
The tank is two 1" endcaps on a small piece of 1" Sch 40 PVC.
You have to drill a hole in one side for the 1/8" thread, and one in the other side for the tubeless tire valve. I also filled in some of the space inside the tank, because an AT3K doesn't need that much volume of air in my opinion.
Then, put your bike pump on, and that's it. I can fill the tank in about 2 pumps, but can pump it 3 times safely.
Since I know probably everyone wants to know, I don't know about ranges yet. However, I did manage to lodge a CS dart half way into a cardboard box from ten feet, so I think that ranges will be plenty good.
Questions, comments, confusion?
Oh, by the way, just thought I would throw this out there. Some are probably wondering what happened to the homemade Vulcan chain. At the moment, I just don't think its gonna work. I'll toy with it again at some point, but the damn thing is made to very tight tolerances, and duplicating them is tough with the tools and time I have.
Edited by analogkid, 14 January 2009 - 11:28 PM.