drop-clip mod
Here is a video of the gun, it was painted with Vinyl dye -
RF20 Death Skull mod

This week it is on Ebay
I'm going to show you where I made my cuts to get the key release to work, and still get average ranges between 35 - 45 ft. with the stock barrels. I use red sonic micros.
You will need:
-phillips screwdriver
-hacksaw
-drill
-hot glue gun
-hammer
To do this first you will need to unscew the magazine and drill straight down the middle. You want the hole to be large enough to fit the key release button up to its widest point. I drilled just enough, then used a hammer to get the release all the way in. When you have this then hot glue it on.

Then you saw the turret post at the end of it's base (where the small part connects) I hammered out the air restrictors and super glued them to the turret.

Don't glue the key release directly to the post stub, instead connect both parts of the key release to the magazine, and then put a little hot glue on the post. Quickly connect your magazine to the gun and hold for a couple minutes. When you do this make sure you get the holes matched up so it gets connected right for a good air seal. Push the key release button and take off the magazine. Then, put hot glue around the sides of the post and release so it stays on. Now you should be ready to test it out. Remember to connect the magazine first and THEN push the button to lock it in place.
Edited by autonerf, 15 April 2009 - 12:08 AM.