12" piece of OMC's PETG
10" Piece of PVC
1/2" PVC coupler
A little over a half inch of Thin Walled PVC
Hot Glue and Hot Glue gun
Pipe Cutters ( You don't really need this but it makes it really easy to cut the barrel of the Launcher. If you don't have one of these a Hack Saw will work. )
Here is the Spy Gear Launcher:
IMPORTANT NOTE: This mod doesn't open the blaster up what so ever. So if you want to plug the pump you should do it now.
The first thing to do is to take or Pipe Cutters ( or Hack Saw ) and cut just a little above the dark piece in the red barrel ( If you hold the blaster up to the light with out the missile you will see a dark spot at the back of the red barrel ). Now after you barrel is off ( Do not throw away the red barrel, you will need this for later ) it is up to you to take out the "X" shape inside the red barrel. I left mine it. Now wrap a lot of E-tape around the stub of the red barrel. Doing this will kill all the dead space in the coupler. After the stub is wrapped take your coupler and slide it on. Make sure the coupler is level. After it is apply Mighty Putty. It should look like this after it has dried:
Now it is your option to spray paint the coupler and the Putty. I did just so it could all match. The first part of the mod is done. Your Spy Gear Launcher can now fire Stafans. Now on to the second.
Take your red barrel pop off the "X" shaped on the top of the barrel.
Now that is done take the barrel and wrap the bottom of the barrel one time. Now take your small piece 1/2" thin walled PVC and slide it over the bottom of the red barrel:
Now hot glue the piece of PVC:
And now your done!
Here is a picture of the final product:
The ranges are pretty good.
Stefan goes from 90-100'.
Missile goes 40-42'.
I Pumped it up to ten times to get these ranges.
I hope you enjoyed this mod.
Edited by Dayko, 27 August 2008 - 01:39 PM.