Really easy to mod this gun. I feel it was easier to mod than a nf.
a cutting device such as a ratcheting pipe cutter
cpvc and coupler
pencil or something
Here are the internals.
Now take out the barrel setup and put the yellow piece into the coupler and mark where the yellow tube goes into the coupler halfway and cut that off. Then wrap it in etape so the coupler fits on snug.
Now trim off excess etape and hot glue the coupler on. Also rough up the area where you are hot gluing.
I wrapped some etape around the area where I glued for some extra strength.
Now you will need to trim the case to fit the coupler.
Now hot glue it in and you are done.
I use a barrel about 7" and it gets at least 50'.
Edited by NerfCrazy, 25 August 2008 - 03:22 PM.