Dremel or sawing instrument
Hot glue gun
Step 1: Take your unmodded quickstrike.
Step 2: Using a dremel or any other sawing instrument cut the barrels off flush with the purple pieces. Then take a knife and clean out the barrels of plastic pieces (I actually cut the barrels shorter after this picture but was too lazy to take another).
Step 3: Using your pipe cutter cut two pieces of cpvc to about 3 inches long and set aside for a second. Take your glue gun and slather the purple parts of the barrels in hot glue.
Step 4: Take the cpvc and force it over the purple part of the barrel. The fit will be snug but it will go on with a little force. Finally you have have your finished product.
Ranges: About 35-40 feet using streamlines with hot glue filled tips. I couldn't take actual measurements because my toolbox got left back at home.
Final remarks: I actually like this little gun. The whole mod take like 10 minutes and it a fun little surprise to ambush my friends with. It could be redone using plumbers goop instead of hot glue but the cpvc is such a snug fit over the barrel I do not believe it is essential.
Edited by Herpestidae, 25 August 2008 - 12:14 AM.