There were only 5 screws so that made it really easy to open up. here are the internals. I think they are similar to the internals of the nitefinder.
You see that piece of foam in the handle. that is the first time i have ever seen that in a not modded gun. It stops vibrations from going crazy in that hollow handle. Good thing for it too since this gun has a lot recoil for it's size. anyways here is the spring it had.
That's a pretty big spring for a gun that size. oh and if you want a reference--it is as long from my wrist to the tip of my middle finger (EDIT: i mean the gun not the spring). i guess i have average sized hands. I wanted to add another spring but the hammer (that's what i call it anyways. it is the thing at the end with the O-rings on it) wouldn't budge even when i unscrewed it. i thought about cutting of the back of the plunger, slip in a spring, then and use a different thing to pull back the plunger since the yellow foam thing looked kinda stupid, but then i figured to keep the extra spring i had for another gun.
So the first thing i did was violently crush off the yellow "barrel" that the dart slid over. (been a while since i modded a gun. might as well have some fun.) This was my end result.
Then I attached an old barrel from the disk shot shooter gun.
The tape is there to keep it in place until i got more super glue. The only glue i had at the time was school glue.
This hole almost got away from me.
here it is with out the detachable barrel
and here it is with the detachable barrel
I did a shot range test with a stefan and an MT20 dart (mech tommy 20)
w/o barrel extension
MT20: about 30 feet flat
stefan: about 40 feet flat
w/ barrel extension
MT20: about 35 feet flat
stefan: about 50 feet flat with a good stefan.
If you know what this gun is please do tell me.
here is a video on it IF you want to see it -->
Edited by KingCosmo7, 08 August 2008 - 08:11 PM.