Jump to content


Ram Rod Mod

Yep more mods by me.

1 reply to this topic

#1 NerfCrazy



  • Members
  • 497 posts
  • Location:Minnesota, 55422

Posted 07 August 2008 - 01:27 AM

So the ramrod is alright but not satisfactory to me.

Alright supplies
Hotglue and hot glue gun
A drill bit a tiny bit smaller than 5/16"(my bit didn't have identification) just about the side of the post
rubber bands

I didn't take a before picture(I can be really stupid) but cut some cpvc about the length of a streamline dart.
Posted Image

Now cut the stuff off of the front like so.
Posted Image

Now use your drill bit and drill a hole where the post used to be( make sure the plunger stuff is pulled back) you can pull the rest of the orange part out if it didn't all come out when drilling.
Posted Image

Now fill in the area around where the old post used to be with hot glue.
Posted Image

Now attach your new barrel with hot glue.
Posted Image

Now in the handle cut a slanted slot on both sides.
Posted Image

Now cut and even more angled one inside the other one.
Posted Image
Then add your bands and you are good to go.
Ranges are at least 30 feet.
(my camera was messed up again <_< )
  • 0

#2 Forsaken angel24

Forsaken angel24


  • Contributors
  • 2,471 posts

Posted 15 August 2008 - 12:03 AM

Glad you could add a new gun to the directory.
  • 0
I don't get my kicks out of you,
I don't feel the way I used to do.
I know its bad,
After what we had,
But Iím just not the angel you knew.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users