Materials
1. Green LED
2. Cable ties (optional)
3. 1/2in. CPVC
4. Toggle Switch
5. Electrical solder
6. AA Battery pack (holds two)
7. Velcro
Here is how you wire a basic LED.
![Posted Image](http://i280.photobucket.com/albums/kk193/Nerfcraft/Nerf%20Diagrams/NerfDiagram6-1.jpg)
You will need, a green LED, a low resistance toggle switch, a AA battery pack (holds two), and silver electrical solder.
![Posted Image](http://i280.photobucket.com/albums/kk193/Nerfcraft/Nerf%20Diagrams/NerfDiagram7-1.jpg)
Connect the wires as shown in the diagram.
![Posted Image](http://i280.photobucket.com/albums/kk193/Nerfcraft/Nerf%20Diagrams/DSC03073-1-1-1.jpg)
Drill a hole for the toggle switch to fit through and tighten the nuts.
![Posted Image](http://i280.photobucket.com/albums/kk193/Nerfcraft/Nerf%20Diagrams/DSC03082-1-1.jpg)
Put velcro on the back of the battery pack and on the connection point.
![Posted Image](http://i280.photobucket.com/albums/kk193/Nerfcraft/Nerf%20Diagrams/DSC03086-1.jpg)
Run 1/2in CPVC down the length of the gun.
![Posted Image](http://i280.photobucket.com/albums/kk193/Nerfcraft/Nerf%20Diagrams/DSC03070-1.jpg)
Insert the LED into the CPVC and you have got a flashlight.
If you have any questions, feel free to comment.
-A side of nerf