Is There A Decent Dtg Mod Out There?
#1
Posted 27 May 2008 - 11:23 PM
I hope to cause no trouble but i hope i can get a response fast because im going to TRU tomorrow.
#2
Posted 27 May 2008 - 11:52 PM
Otherwise, I believe it might be easier to use brass; Generally with a little sanding you can just jam the barrels in with some hot glue into the stubs, and then sand the inside of the turret housing and slide it right over the brass. You end up with a lot more support that way.
The thread I'm assuming you referred to uses 3" barrels.
~ompa
#3
Posted 27 May 2008 - 11:55 PM
It will be the usual mod; remove the turret housing, make sure you can cut straight, and then put a bunch of cpvc stubs onto the turret base. Use hot glue/epoxy putty/plumber's goop/epoxy (whatever glue you want to use) to mount the barrels. The length of the cpvc should depend on the darts you will be firing out of it; shorter the tighter the darts are, longer the looser they are. Saw off the barrel stubs on the turret base as you see fit.
Otherwise, I believe it might be easier to use brass; Generally with a little sanding you can just jam the barrels in with some hot glue into the stubs, and then sand the inside of the turret housing and slide it right over the brass. You end up with a lot more support that way.
The thread I'm assuming you referred to uses 3" barrels.
~ompa
okay sounds good. Also what size brass should i try?
#4
Posted 27 May 2008 - 11:59 PM
And do try to use proper capitalization. It's in the Code of Conduct.
~ompa
#5
Posted 28 May 2008 - 12:02 PM
It's not like that. I put lube on it and its the same. Its just stuck. And when I cock it back it goes farther back then usual. Also I push as hard as I can and it wont go back in. I've tried the methods and they wont work. Also pics are up.
#7
Posted 28 May 2008 - 04:19 PM
Edited by Bomberman, 28 May 2008 - 04:20 PM.
It's not like that. I put lube on it and its the same. Its just stuck. And when I cock it back it goes farther back then usual. Also I push as hard as I can and it wont go back in. I've tried the methods and they wont work. Also pics are up.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users