Here is a picture of the gun.
A closer picture of the stock.
- 1/2in PVC
- 1in PVC
Then put one half around the rail and glue the other half to it. Now the shaft is around the rail. Glue it to the rail divider and anything else for support. Do the same for the other rail.
Then cut a piece of 1in PVC the length indicated in the picture below.
Attach one end of the PVC to the divider with hot glue. Make sure you don't attach the other part because it won't be able to detach from the gun.
The finished product should look like this.
I wrapped some of the PVC in electrical tape. This gun looks a lot cooler with the nozzle on the front, but it's at my friends house right now.
If you have any questions, feel free to comment.
-A side of nerf
Edited by A side of nerf, 27 May 2008 - 12:54 PM.