![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3507.jpg)
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3508.jpg)
Materials needed:
Knock off Tech Target
17/32 Brass
Hot glue and hot glue gun
Duct tape
Screwdriver
Silicon or lube of choice
Rubber bands
First unscrew the case apart.
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3509.jpg)
Next take out the plunger assembly, rip off the plunger from the yellow part and lube the plunger tube.
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3510.jpg)
Next take off the yellow AR from the front of the plunger tube.
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3511.jpg)
Then hot glue a two and one half-inch piece of 17/32 Brass to the plunger tube.
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3512.jpg)
After that glue the plunger assembly back together and add duct tape.
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3515.jpg)
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3516.jpg)
Then screw the case back together and hot glue around the barrel.
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3517.jpg)
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3518.jpg)
Now slap some rubber bands on it and your good to go.
![Posted Image](http://i231.photobucket.com/albums/ee317/nerfalchemist/IMG_3519.jpg)