Ok so First step is to open up your gun. (I took out all of the safety/not fuck up your gun mechanisms)
Second take out the plunger tube and unscrew the small silver screws:
Now take off the plunger head by unscrewing this screw:
Now slip in your NF spring/spring of choice:
Now put the plunger head back on.
Now we have to take out those damn the ARs. I did this by hammering the prongs on the ARs out with a flat head screwdriver like this:
Then prying it out with some needle nose pliers.
Oh and the AR will look like this:
There will be a small hole at the back of the bolt that you should plug up with hot glue/epoxy/plumbers goop.
Next put the whole plunger assembly back together.
Wheew we have that clusterfuck out of the way.
Ok Now to the actually making it shoot taggers/suckers/whistlers.
Cut the end of the bolt off all the way to the bolt sled. Refer to This
Now You have to Dremel the hell out of it until I't will fit your dart without the head bending down and the bolt is not falling off the bolt sled, this is what I got:
Once you have that done, make sure everything is in place and put it all back together.
Cool, now load up some darts into your clip and go shoot someone!
It gets ~50'-60' which is not too bad for a non brass breached LS.
Questions? Comments? Flames? Bring it on.
A few more pics:
Darts in magazine:
Yeah the reason I cut the bipod off is because I am *attempting* to do DartAttack's front gun integration. Oh an I know my shop is messy.
PS: You may need to snip about a half of a CM off of the end of the taggers because they are slightly longer and may jam in the bolt.
Edited by Spartan_117, 30 April 2008 - 07:55 AM.