I did this mod because of my inability to open up the gun due to rusted in screws. Fuck Goodwill stuff.
For such a simple modification, it turned out quite well.
Anyway, I'll get on with it.
You will need:
Titan
Your choice of barrel material.
Duct tape
E-Tape
and nesting material.(PVC, etc.)
Ok, step 1.
Take the PVC
and the PETG
and nest them. This will act as the base.
I used 12" of PETG inside roughly 2 1/2 inches of Sch.80 PVC.
Step 2.
Put this piece aside, you wont be using it for this mod.
Step 3.
Now line the nested PETG up with the inner threaded stub.
I removed the AR, however, you don't have to.
^ompa's picture^
Wrap duct tape around as necassary.
I then sealed it with E-Tape. It is airtight now.
I used metal duct tape to stabilize it.
Finished product:
It may be fugly, but it took about 10 minutes to do, and gets 160' flat.
Disclaimer: I am 6' 2", and I shot from my shoulder.
Edited by sputnik, 15 April 2008 - 02:11 PM.