9 replies to this topic

[Spyder Snyper]

How did you guys (if you did) open your at2k? With the pump thinggy glued into place? I do not have a dremel so is their any other way to open it? Thanks.

[xNFx 37]

You can hacksaw it open. DO NOT cut through the pump though.

[ChiliPepperFender]

I remember reading a question about this and someone said to "Rip that shit out" or something. Which is what I did, it actually worked. All I did was pull the two halves apart. Not as clean as hacksawing but much funner.

[jake44]

I usually heat up a butter knife over the stove, and that works just fine. Just be careful not to go too far in!

[imaseoulman]

You can just crack it. Sometimes, you get lucky and it just slides right out. Just unscrew it, lift one sie and pull back.

[nerfboi]

Just pull like h**l and it will come off.

[Bomberman]

Hey, Nerfboi, you don't have to star out cusses, especially only 'hell'. But anyway, what you should do, is take a large flathead screwdriver, get it under the piece, and then take a hammer, and hammer against the end of the screwdriver, and move it around, and then just pry it off. But trust me, it is not a good idea to heat a butter knife on the stove. It just is'nt smart. You don't want to just melt it.

[nerfboi]

Yeah, but still, some little kids come here. Who knows. But yeah your right. Eh, i guess I won't star it out anymore.

[BendyStraw]

Like most materials, you will also get good results by bending it back and forth, back and forth. A paperclip will snap when you bend it too much, and I've noticed that when you try to tear plastic stuff like anti-mod glued in nerf parts, you can usually "tear that shit out" but bending it back a couple of times results in a cleaner tear, because it stresses the point that is being warped so that it gets weaker.

[Ro-Sham-Bo]

I got pissed when mine wouldn't open so, I smacked it with a hammer. After a few blows, it opened right up.