1. Is the purple primer alright to use? I havent seen any homemades with purple on them...
2. Should I seal around the pump valve? In the homemades section I though i read that it made a good enough seal but could i make it better? If so what should I use? I would think that the air pressure would push the valve out further though so the seal would get better when i fill it...
3. Is it ok that I am using around five reducers to go from 2 inch to .5 inch? I'm just curious because my lowes and home depot did not have any straight from 2 to .5 inch.
Thankyou for all your help.
edit: added a third question
Edited by Kid Flash, 02 April 2008 - 04:29 PM.