Anyways, here's your SpeedLoader.
![Posted Image](http://img390.imageshack.us/img390/6702/picture1051ha1.jpg)
Crack her open. The only weird part about this is that the pump handle is halved and each half is attached to it's side of the shell.
![Posted Image](http://img233.imageshack.us/img233/8355/picture1052rl0.jpg)
Now take out the plunger assmembly. You have to unscrew the two screws holding the chamber in, as seen in the picture.
![Posted Image](http://img217.imageshack.us/img217/7021/picture1053au2.jpg)
Take apart the orange piece, it should split in half.
![Posted Image](http://img217.imageshack.us/img217/11/picture1054kj9.jpg)
Now get some 1/2" PVC, and cut a 1/2" segment., Completely take off the orange piece, and then slide the PVC piece in behind the spring. Replace the orange piece and put the assembly back in.
![Posted Image](http://img353.imageshack.us/img353/4604/picture1056nv0.jpg)
Now take out the turret. Unscrew these two screws at the back.
![Posted Image](http://img353.imageshack.us/img353/9099/picture1057ey5.jpg)
Now cut the middle piece away from the barrel casing.
![Posted Image](http://img359.imageshack.us/img359/5725/picture1059pu3.jpg)
Keep all of that^. Now cut the stock barrels off. This is a long and grueling process if you don't have access to a bandsaw or something of the like (which I didn't). It should look something like this afterwards.
![Posted Image](http://img440.imageshack.us/img440/1771/picture1073of8.jpg)
Now screw the middle piece back into the turret base, and make sure the insides of the middle piece look like this:
![Posted Image](http://img369.imageshack.us/img369/6982/picture1065oq6.jpg)
Screw it back in, and now cut eight 3" pieces of CPVC.
![Posted Image](http://img223.imageshack.us/img223/8107/picture1074sf0.jpg)
Now start glueing on your barrels. First put some Goop or epoxy down on the barrel stub.
![Posted Image](http://img204.imageshack.us/img204/3438/picture1075sw8.jpg)
Now put the barrel on and use some hotglue to secure it while the Goop dries.
![Posted Image](http://img386.imageshack.us/img386/6669/picture1078yf5.jpg)
Do that for the entire turret. The finished product.
![Posted Image](http://img172.imageshack.us/img172/4087/picture1083tf0.jpg)
Now we prepare the barrel sheeth. Cut off the top most part.
![Posted Image](http://img361.imageshack.us/img361/4458/picture1064yt1.jpg)
Now glue it down to the turret base. After it's glued put it back in.
![Posted Image](http://img361.imageshack.us/img361/6899/picture1088ou8.jpg)
Finished Internals.
![Posted Image](http://img172.imageshack.us/img172/9697/picture1089xy6.jpg)
Screw it back up and you're done!
![Posted Image](http://img172.imageshack.us/img172/9168/picture1094ra1.jpg)
I don't know ranges as of yet, but probably in the mid 50's. I'll try and get some up tomorrow.
Questions, Comments?
-OfAll'
Edited by OfAllTheNerf, 31 March 2008 - 07:36 PM.