All right so I have seen one mod for the Triple Shot and that uses brass and I didn't have any so I used OMC's 1/2" thick walled PETG. This mod is really easy you need these things.
- Tape
- Hot Glue
- 1/2" PETG 3 1/2" length comes out to 3" long so 4" for a 3 1/2 " barrel
- Something to cut PETG
Then wrap them in tape so the PETG fits snugly over them
Then put hot glue on the end of the PETG and put it over the tape and add hot glue around the base for a better hold.
Then repeat until done. (I didn't finish mine because I was running low on tape)
Ranges were about 47-53 wind played a bit of a role 43-48 against the wind and 50-55 with the wind.
Here is a size comparison
Edited by NerfCrazy, 29 March 2008 - 10:16 PM.