Something to cut with
40 lb fishing line
Titan with Absolver mod (or similar)
Upon opening my titan, I found that the vinyl tubing to my pressure gauge looked like this
Instead of this (Which we also end up removing)
So, in addition to removing the stuff around our integration point (the bottom handle) I went about cutting off the gauge as well.
Use whatever you like to cut, and cut the vinyl tubing between the check valve for the hornet, and the pressure gauge. After you cut the pressure gauge, unscrew the white cap holding the tubing. This allows you to pull it out.
Take your epoxy and goop over the holes you've just made. This is what mine looked like right after I epoxied.
After this, I tore out anything related to the Scout, as I don't have one, and the rest of the hornet parts (like the trigger) as it is now pointless.
All in all, remove this stuff.
It's not necessary, but I completed the hole that the pressure gauge was resting in.
Now we dremel out the bottom handle. Make it look like this,
and don't forget to dremel out the front to allow the pump tube to poke through.
I don't have any more open pictures of the blaster, but place your 2k internals in the shell, pump in the clean dremeled space, air tank and liquitron hanging out. If you didn't notice the dremeled holes for the 2k's tubing in the other picture, dremel holes for it through the bottom of the titan's handle. Glue the pump tube in place. Close up the titan.
Glue the barrel of the 2k to the bottom of the squarish jut on the front handle. Because the vinyl tubing is trying to expand, your barrel will point upwards. I used 2 zip ties to fix this- one on the tubing, one on the barrel.
Lastly, the trigger system. Take your fishing line and cut about a foot off. Lace it through the spring on the firing pin, and tie it off. Cut about an inch of your straw, and thread the line through it. Glue the straw to the side of the titan's handle. This will keep it in place while you run. Tie the rest of the line around your key ring, and cut off the excess.
You're done! I would only keep about 4 pumps in the airtech, like any other. As for the titan, I didn't plug the overpressure valve, so I just pump until it kicks in.
Ranges are typical. The 4 shot titan gets around 80', and the airtech about 110'.
This was my first integration, and while it's not very clean, I'm proud of it. This has been an Aslan Arms production.
Questions? Comments? Flames?
Edited by lionhead333, 08 March 2008 - 09:44 PM.