Marterials Needed
- CS6 Recon
- Some of OMC's PETG
- Some other smaller size PETG that fit inside of OMC's PETG
- E-tape
- Screwdriver
Optional: Super glue
Here it is Stock:
Heres stock internals:
Thanks to umdlancer for this pic(I take no credit for this pic)
Next you tak out the bolt, and then remove the pin on top:
Again, thanks umdlancer for the pic(I take no credit for this pic)
Then you have to somehow remove the AR's. I used allen keys/wrenches. I shoved it in the back and started to twist so it would grind the back preventing the AR from falling out
Then I used PETG instead of brass like chefdave. I used some size(i forgot which one) PETG to do this:
You could super glue/Epxoy a little of on the outside to give it a better seal, but I didn't mainly because I didn't have any but super glue.
What I did was I found 1 size of PETG and test it if it would go into some of OMC's GREAT PETG. And is was PERFECT fit.
Then I took the other PETG and I wraped E-tape around it so it would fit inside the big orange barrel like thing:
Then in to this thing:
Then you would just put it back together. (See 2nd picture from the top)
This is what mine looked like:
Any Questions? comments? possible flames?
Thanks for OMC for the PETG and for anyone who actually likes this.
Im not soo sure about hte ranges because I jsut finished this and it's like 10 over on the westside. So I'll get back to you on that.
Edited by nerfboi, 03 March 2008 - 01:18 AM.