I am building a plunger gun and need some help. It is setup like a SNAP with .75" in 1.25" PVC. What size o-ring should I be using?
2 replies to this topic
#1
Quilan Fett
-
- Members
- 678 posts
Member
Posted 27 December 2007 - 12:14 PM
SNAP Shotgun
This guy can see the future!
hasbro in a nerf war!!!!! dude the will cancel it and confinscate are guns
This guy can see the future!
QUOTE(pokemaster @ Mar 3 2009, 04:18 PM) 
hasbro in a nerf war!!!!! dude the will cancel it and confinscate are guns
#2
PharaonArin
-
- Members
- 79 posts
Member
Posted 28 December 2007 - 04:29 PM
Take your plunger to your local hardware store then find a o-ring that fits it.
Edited by PharaonArin, 28 December 2007 - 04:29 PM.
#3
Carbon
-
- Moderators
- 1,894 posts
Contriberator
Posted 28 December 2007 - 06:25 PM
You won't get any o-rings to fit without some kind of cutting: the space between endcap and PVC is very close in this size (one turn of e-tape is too tight). Your best bet would be to use the cut endcap method: cut the endcap in half, and shove the two parts on some .75" PVC with a gap in between. Then build up the gap a bit with e-tape, up to a perfect fit. This way, you can just buy a thick enough ring that will snugly fit on PVC, and not worry too much about exact sizes. (the ring will stretch)
Hello. I am Indigo of the Rainbow Clan. You Nerfed my father. Prepare to die.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
