What you will need:
Eagle eye
1/2" CPVC
Etape or whatever tape you prefer
Alright, so what we are doing is basically putting a CPVC barrel into the eagle eye's barrel.
First, cut a section of your CPVC. I cut off 4" for this particular mod, but you can cut whatever length to your preference.
Next, wrap 2-4 layers of tape around the middle, or near the end of the CPVC that will actually be inside the barrel.
Now, shove the barrel into your eagle eye, and you're done! It should fit snug into the barrel. If it takes too much force to get the barrel in, then take off a layer of tape. If its too loose, add a layer, and so on.
I haven't gotten ranges yet, because its raining hard out here on the east coast. I will try to get them when the storm passes over. I did shoot it once outside (That wasn't the only time I shot it, but it was the only time I did outside) and it looked to get around 70' flat from about 5' off the ground, shooting a stefan. I know that sounds too good to be true, but I was also surprised how far it shot with such a simple mod. Another note: when I used a stefan, ramrodding it didn't do so well, what I did was simply removed the CPVC, put the stefan in the back end of it, replaced it into the gun, and it works extremely well.
Hopefully I get put into the directory for this!
Questions??
