It will use the wire to hold the clip in place and you manually push up to load the next dart. Should be cheap and easy. The AutoCAD isn't done yet, it needs the side panels, they onld the two pieces of PVC to each other.
New Clip
Easy Cheesy
Started by
General Cole
, Sep 05 2006 09:42 PM
3 replies to this topic
#1
General Cole
-
- Banned
- 868 posts
Member
Posted 05 September 2006 - 09:42 PM
Pic-
It will use the wire to hold the clip in place and you manually push up to load the next dart. Should be cheap and easy. The AutoCAD isn't done yet, it needs the side panels, they onld the two pieces of PVC to each other.
It will use the wire to hold the clip in place and you manually push up to load the next dart. Should be cheap and easy. The AutoCAD isn't done yet, it needs the side panels, they onld the two pieces of PVC to each other.
We should stop calling out/making fun of/pissing GC off. He's actually contributed and is available for trade. He's a better than average member no doubt. Got your back Cole.
-Nerfer34
You know what... I know it's kinda late... but Props Cole.
-Baghead
-Nerfer34
You know what... I know it's kinda late... but Props Cole.
-Baghead
#2
Carbon
-
- Moderators
- 1,894 posts
Contriberator
Posted 05 September 2006 - 10:05 PM
Can you make that pic a little bigger?
Hello. I am Indigo of the Rainbow Clan. You Nerfed my father. Prepare to die.
#3
IN-THE-DARK
-
- Members
- 22 posts
Member
Posted 05 September 2006 - 11:51 PM
Wow! I was just thinking about doing a clip like that.
#4
blinkycc13
-
- Members
- 74 posts
Member
Posted 06 September 2006 - 06:04 PM
Correct me if I'm wrong because the pic is small, but it looks kinda like a revolver, but straight. The issue with these is always getting a good seal. Good luck though!
QUOTE(Dark Shrimp @ Nov 10 2006, 11:06 PM) 
This is called a screwdriver it is used to unscrew or screw in screws.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
