Where To Buy Modding Materials Where to get, and where not to get
Posted 26 April 2012 - 05:39 PM
Posted 26 April 2012 - 07:31 PM
EDIT: I just remembered FA's website, which has beige. Anyone know of anywhere else?
This post has been edited by Ivan S: 26 April 2012 - 09:24 PM
Posted 30 April 2012 - 06:05 PM
They are the best deodorant clips and are great to integrate into flywheel guns. It hold 9-10 darts, and can be either attached as a clip, or left in with the bottom removed to just drops darts in for quick reload.
They can be purchased for $3-4.50 at almost any large retail store or CVS or Walgreens pharmacy.
I suggest you use them first as they are not cheap.
Everything you're saying is wrong, but none of it is against the rules. I just wanted you to know that.
Posted 20 May 2012 - 05:16 PM
EDIT: Thanks Daniel. I'll try electrical conduit. I was also just fooling around in my basement and remembered that the faux barrel from Recons and Longshots slip over CPVC well also. I may cut a segment of that stuff off and try it as well.
This post has been edited by ShaNayNay: 21 May 2012 - 07:13 PM
Posted 20 May 2012 - 06:50 PM
Electrical conduit sometimes works. Bring a stub of CPVC to the store and test sections of it - the tolerances are very sloppy, and so sometimes you can find a batch which works.
This post has been edited by Daniel Beaver: 20 May 2012 - 06:50 PM
Posted 14 July 2012 - 12:45 PM
Just as extra "evidence/proof", for the "1/2" x 4' Heavy Wall Round Clear Plastic Tube" (yes, I do realize that it is different from thinwall PETG), there is a button that says "Need a Smaller Quantity? Click here." right below the image of the product which redirects you to McMaster-Carr's website.
Sorry, I forgot the link.
Note: Yes, it is a slightly different product, but I'm just trying to point out that if VisiPak supplies McMaster-Carr with thickwall PETG, it most likely also supplies them with their thinwall PETG (or "cut to length plastic tubes" if you want to be technical)
Oh, and also, for the AmazonSupply website, would "Clear Polycarbonate Tubing" (link) be a suitable alternative to PETG? It's a good deal more expensive and also happens to be out of stock currently (or I would have ordered some to test). Thanks!
This post has been edited by Briguy52: 14 July 2012 - 12:53 PM
Posted 01 August 2012 - 03:31 PM
EDIT: I found some 9/16 brass http://www.hobbylinc.../k+s/k+s141.htm This site is better than the hobby people site. They have everything you need to make an angel breech brass-wise.
This post has been edited by therealnerfjunkies: 05 August 2012 - 09:12 PM
Posted 28 August 2012 - 05:25 PM
Also, I think Mod Man is selling some red foam as of now. Click this to go to the thread.
Posted 19 September 2012 - 05:14 AM
Edit: yea sorry for talking about amazon again even though its in the forum already. but the prices were not talked about and so that is a good piece of info.
This post has been edited by Super0dp: 19 September 2012 - 05:18 AM