The entire reciever is likely to be two section of 1/1/2" PVC. Similar to the CO2 rifle. It will use the same shells as the CO2 rifle. I am thinking I may have to modify them however by putting another ring around the shell for better seating in the magazine and better cycling. If this is required it will not affect there use in the CO2 rifle.
Here is a shot of it with my M4 just for comparison......
I hope to do some fabricating over the Xmas break. During the scmester I don`t get much free time. I`ll keep you guys informed.
This post has been edited by boltsniper: 20 December 2004 - 06:23 PM