I recently made a mount for my own camera (Samsung W200).
My Camera has the tripod mount on the bottom left corner, so you might need to make yours slightly different.
I started by cutting a piece of wood a little bit larger than the bottom of my camera.
Then I took a sharpie and marked where the the tripod mount would go on the camera.
Next, I drilled a 3/16 hole where the screw would go.
After that, I took my 1/4in screw to see if it fit.
The next steps are to show you how I attachted it to my SNAP.
I took a scrap piece on 1" PVC and cut it in half. Then I marked 2 dots, 1 for the screw and one to attatch to the SNAP.
I drilled another 3/16 hole for the 1/4in screw and a 1/8 hole for the screw that attatches to the gun.
Finally, I attatched it to the front of the stock of my SNAP.
I hope this helps.
Edit: Here is a quick video I took with the mount. My mount is attatchted at an angle so the video looks a little slanted.
This post has been edited by sharvil06: 24 March 2012 - 09:59 AM