1. 10" of CPVC
2. Hot glue gun/ hot glue
3. Buzzbee Rogue
4. 30-45 minutes of your time.
5. Scroll saw/ band saw
6. Small screwdriver
7. Flat file
First, take your 10" piece of CPVC and cut it into 4 x 2 1/2" pieces:
Then, open the blaster and take the turret out.
Next, chop the retarded stock barrels off of the turret so it looks something like this:
Take a flat file and smooth down the stubs on the center posts and the former spots of the barrels:
Next, take your pieces of CPVC and start gluing them onto the turret like so:
After all 4 barrels are glued on, it should look something like this:
Place the turret back in the blaster:
Close the blaster up and you're done!
Average range: 50 feet
This post has been edited by Eraser475: 30 November 2011 - 06:19 PM